Here's a discussion about replacing the control board on the MakerBot with a different one:
https://www.quora.com/Is-it-possible-to ... a-MakerBot
In general you wouldn't use a Pi inside a 3D printer to directly control the hardware. Usually there is a dedicated controller board.
You could use a Pi running Octoprint to manage your 3D printer. It's a great combination.
https://www.quora.com/Is-it-possible-to ... a-MakerBot
In general you wouldn't use a Pi inside a 3D printer to directly control the hardware. Usually there is a dedicated controller board.
You could use a Pi running Octoprint to manage your 3D printer. It's a great combination.
Statistics: Posted by ame — Sun Jul 28, 2024 8:24 pm