Beginners • Re: DHT11 sensor with Raspberry Pi Pico

As for the pull-up resistor, either of these will work, and use whichever is more convenient to you:

• between DATA and VCC on the DHT11; or
• between the VCC breadboard power rail and DATA on the DHT11;
• (between the VCC breadboard power rail and GP16 on the Pico would also work)

Could I ask for you to explain it a bit simplier? Let's say I have the DHT11 on the breadboard with everything connected to it. Is that how I should do it in a more straight-forward explanation?
1 put one end of the 10kOhm resistor in DATA and one in VCC
2 put one end of the 10kOhm resistor in DATA and one in the power rail
3 put one end of the 10kOhm resistor in the GP16 and one in the power rail

Statistics: Posted by Dethress — Tue Jun 25, 2024 1:46 pm

---