Raspberry Pi OS • Send Ir command with IR-CTL

Hi guys, I need a hand. I captured the commands of my remote control for the tv using IR-KEYTABLE. I have everything acquired and created the toml file. If I do some tests by pressing the button in front of the receipt it gives me the stored command back so the file should be correct. But the problem arises when I have to send the command from the led transmitter using IR-CTL command. When the command is launched, nothing happens, the LED on the transmitter board lights up to indicate that the signal has been sent. Do you know if the syntax is correct or could there be some hardware problem? I'll leave you what I configured.

I set to /boot/config.txt
dtoverlay=gpio-ir-tx,gpio_pin=18


You threw a photo of the command I sent.

Thanks a lot to everyone

Statistics: Posted by Dende90 — Wed Jun 12, 2024 10:10 am

---