Hitec D646WP
Min pulsewidth - 0.000850
Max pulsewidth - 0.002350
I found a data sheet that indicated these two numbers as PWM signal range. I would have to say it worked. What before required a servo.value = 1 now gets the same location with servo.value = 0.6.
The servo is now installed and will break the mount if I go all the way to 1.0, but I assume it will now.
Thanks for the replies and I'm lucky the thing I need is so simple, because this gpiozero is a terrible way to run a servo. The jittering must reduce its lifespan.
Min pulsewidth - 0.000850
Max pulsewidth - 0.002350
I found a data sheet that indicated these two numbers as PWM signal range. I would have to say it worked. What before required a servo.value = 1 now gets the same location with servo.value = 0.6.
The servo is now installed and will break the mount if I go all the way to 1.0, but I assume it will now.
Thanks for the replies and I'm lucky the thing I need is so simple, because this gpiozero is a terrible way to run a servo. The jittering must reduce its lifespan.
Statistics: Posted by squirreltown — Tue May 07, 2024 4:56 pm